6. Screw kit (SK93) 7. HF Microphone (MIC40) 8. Installation Manual (IMCMT9300) • Your CMT9300 kit does not include the following parts: 9. Stand for Cradle 10. Screw (M5 × 25) Inst.Guide_body Adobe PageMaker 6.5J/PPC Page 1 02.4.3, 11:38 AM...
Page 3
2. Mount the Transceiver unit To install the cellular telephone with the transceiver unit located in the trunk-space of the automobile follow the steps outlined below. a. Place the mounting bracket so that the four bracket holes line up with the trans- ceiver holes.
Page 4
4. Mount the Cradle and Handset a. Using a pedestal mount. The cradle unit can be mounted as displayed. Be sure to use only supplied M4 × 8mm screws. Using improper screws will damage the cradle unit. b. Plug in the handset and Hands-Free Mic.
5. Antenna The following are recommended antenna and cable installation instruction for Trans- ceiver unit. These instructions must be followed in order to comply with the FCC RF exposure requirements. • Standard type 1 Antenna type Glass mount type (“thru–glass” antenna) - Colinear Mount location : Rear window of a vehicle Antenna cable :...
Page 6
• Standard type 3 Antenna type Colinear Mount location : On the right of trunk lid Antenna cable : SUMITOMO 2.4DS-GXLA, 2.5DS-GXCA 8.85 feet (2.7m) or longer Install the antenna on the right position of the trunk lid as shown in the diagram below.
Page 7
• Standard type 5 Antenna type Roof top mount type-1/4λ Mono type Mount location : Roof top of a vehicle Antenna cable : SUMITOMO 2.4DS-GXLA, 2.5DS-GXCA, 2.5DS-GXCA 12.30 feet (3.75m) or longer Install the antenna on the center position of the roof top as shown in the diagram below.
Need help?
Do you have a question about the CMT9300 and is the answer not in the manual?
Questions and answers