Related Manuals for Audiovox CMT9300
Summary of Contents for Audiovox CMT9300
- Page 1 INSTALLATION GUIDE FOR CELLULAR CAR TELEPHONE 555 Wireless Blvd., Hauppauge, NY 11788 288E9930...
-
Page 2: Exposure To Radio Frequency Signals
SAFETY INFORMATION FOR WIRELESS MOBILE PHONES READ THIS INFORMATION BEFORE USING YOUR MOBILE CELLULAR TELEPHONE EXPOSURE TO RADIO FREQUENCY SIGNALS Your wireless mobile telephone is a low power radio tran- smitter and receiver. When it is ON, it receives and also se- nds out radio frequency (RF) signals. -
Page 3: Electronic Devices
DRIVING Check the laws and regulations on the use of wireless telephones in the areas where you drive. Always obey them. Also, if using your phone while driving, please: • Give full attention to driving - driving safely is your first responsibility. -
Page 4: Blasting Areas
BLASTING AREAS To avoid interfering with blasting operations, turn your unit OFF when in a “Blasting area” or in areas posted “Turn off two-way radio”. Obey all signs and instructions. POTENTIALLY EXPLOSIVE ATMOSPHERES Turn your phone OFF when in any area with a potentially explosive atmosphere and obey all signs and instructions. -
Page 5: For Vehicles Equipped With An Air Bag
For Vehicles Equipped with an Air Bag An air bag inflates with great force. DO NOT place objects, including both installed or mobile wireless equipment, in the area over the air bag or in the air bag deployment area. If in-vehicle wireless equipment is improperly installed and air bag inflates, serious injury could result. -
Page 6: Installation Procedure
3. Power Cable (EPC91) 4. Extension Cable (EIC91) 5. Clamshell (CM5) 6. Screw kit (SK93) 7. HF Microphone (MIC40) 8. Installation Manual (IMCMT9300) • Your CMT9300 kit does not include the following parts: 9. Stand for Cradle 10. Screw (M5 × 25) - Page 7 2. Mount the Transceiver unit To install the cellular telephone with the transceiver unit located in the trunk-space of the automobile follow the steps outlined below. a. Place the mounting bracket so that the four bracket holes line up with the trans- ceiver holes.
- Page 8 4. Mount the Cradle and Handset a. Using a pedestal mount. The cradle unit can be mounted as displayed. Be sure to use only supplied M4 × 8mm screws. Using improper screws will damage the cradle unit. b. Plug in the handset and Hands-Free Mic.
- Page 9 5. Antenna The following are recommended antenna and cable installation instruction for Transceiver unit. These instructions must be followed in order to comply with the FCC RF exposure requirements. IMPORTANT: To meet the FCC's RF Exposure Guidelines, the antenna should be installed to ensure a minimum distance between the user and nearby persons and the antenna.
-
Page 10: Standard Type
• Standard type 3 Antenna type Colinear Mount location : On the right of trunk lid Antenna cable : SUMITOMO 2.4D-GXLA, 2.5DS-GXCA 8.85 feet (2.7m) or longer Install the antenna on the right position of the trunk lid as shown in the diagram below. - Page 11 • Standard type 5 Roof top mount type-1/4 λ Mono Pole Antenna type Mount location : Roof top of a vehicle Antenna cable : SUMITOMO 2.4D-GXLA, 2.5DS-GXCA, 2.5DS-GXCA 12.30 feet (3.75m) or longer Install the antenna on the center position of the roof top as shown in the diagram below.