Audiovox Pursuit PRO 9232 Installation Instructions Manual

KEYLESS ENTRY ALARM UPGRADE MODULE
PRE - INSTALLATION NOTES :
This system provides an output that is used to drive the siren, and an output that can pulse the vehicle's horn. When
utilizing the horn, an additional relay maybe required. Caution: on many vehicles the factory horn is not
designed for continuous use, and it is recommended that the siren is used for these vehicles. Check to see
if the horn in the vehicle is the same part that is used in a vehicle with the factory installed security system.
When installing the PRO-9232 as a stand alone passive alarm system, the following programmable features must
be set:
Feature #5 set to Passive.
Feature #7 set to Delay.
Feature #8 set to 1 Wire Disarm.
IMPORTANT : In the entry delay mode, when the alarm is armed actively, the doors will trigger the alarm
instantly. The entry delay will only take place when the alarm is allowed to arm passively!
IMPORTANT : THE ENTRY DELAY WILL NOT OPERATE WHEN THE VOLTAGE SENSING CIRCUIT,
FEATURE # 6, IS ACTIVE
This system includes an additional transistorized ground output that can be used to trigger an external remote starter
or remote window closure module. This is the Green w/Black trace wire, and it is activated by pressing the Lock,
then Unlock, then Lock buttons on the factory transmitter within a 3 second time period.
This system will allow the activation of remote panic using the factory transmitter. Pressing the Unlock, the Lock,
then Unlock buttons on the factory transmitter within a 3 second time period will activate the remote panic feature.
This system provides a positive trunk release input, which allows the activation of the remote trunk release from
the OEM transmitter without triggering the alarm, even when the system is armed.
This system provides a valet/manual override switch which is operable by use of a custom code override or only
after the system is disarmed. There is no need to conceal this switch as the override code is known only to the
operator.
Because of the complexities of the different factory installed Remote Keyless Entry Units on the market today, the
PRO- 9232 uses two disarm inputs. Whether installing into a vehicle using a 2-step unlock circuit, single step unlock
circuit, or as a stand alone passive alarm, both disarm wires must be connected in all installations.
The arm and disarm functions of this system are learned during power up, by monitoring the resting state of the
factory wires when power is applied to the unit. Be certain all wires are connected to the vehicle before applying
power to the circuit to insure the system responds only during operation from the factory transmitters.
NOTE: By design, if feature #8 is set to the "ON" position, (1 wire disarm), the alarm will not disarm while the
system is in the triggered mode.
STAND ALONE PASSIVE ALARM
AUXILIARY FUNCTION or REMOTE START OUTPUT
REMOTE PANIC
TRUNK TRIGGER BY - PASS INPUT
VALET / MANUAL OVERRIDE SWITCH
UNDERSTANDING DISARM #1 AND #2:
Model PRO 9232

INSTALLATION INSTRUCTIONS