Sms To A Pabx; Activating/Deactivating The Sms Function; Sms Troubleshooting - Siemens Gigaset S450 Owner's Manual

07.09.2005
SMS (text messages)

SMS to a PABX

u
You can only receive an SMS when the
Calling Line Identification is
forwarded to the extension of the
PABX (CLIP). The CLIP of the phone
number for the SMS centre is
evaluated in your Gigaset.
u
If required, you must prefix the number
for the SMS centre with the access
code (depending on your PABX).
If in doubt, test your PABX e.g. by
sending a text message to your own
number: once with and once without
the access code.
u
When you send SMS messages, your
sender number may be sent without
your extension number. In this case the
recipient cannot reply to you directly.
Sending and receiving SMS on ISDN
PABXs is only possible via the MSN
number assigned to your base station.
Activating/deactivating the
SMS function
When you switch off you cannot send or
receive any SMS with your phone.
The settings which you have made for
sending and receiving SMS (e.g. the call
numbers of the SMS centres) and the
entries in the incoming and draft message
lists are saved when you switch off your
phone.
v
Open menu.
5 5 O 2 L
Enter the digits.
Q
Deactivate the SMS function.
§OK§
Or:
1
Activate SMS function (default
§OK§
settings).
30

SMS troubleshooting

Errors when sending
E0 Calling Line Identification permanently
withheld (CLIR) or Calling Line
Identification not activated.
F Error occurred during SMS transfer.
E
F Connection to SMS centre failed, see self-
D help.
Self-help with errors
The following table lists error situations
and possible causes and provides notes
on troubleshooting.
You cannot send messages.
1. You have not requested the CLIP service
(Calling Line Identification Presentation).
¥
Ask your service provider to enable this
service.
2. Text message transmission has been
interrupted (e.g. by a call).
¥
Re-send the text message.
3. Feature is not supported by network
provider. .
4. No number or an invalid number is entered
for the SMS centre activated as the send
centre.
¥
Enter the number (page 29).
You receive a message whose text is
incomplete.
1. Your phone memory is full.
¥
Delete old messages (page 26).
2. The provider has not yet sent the rest of the
message.
You have stopped receiving messages.
1. You have changed the ID of your mailbox.
¥
Tell your SMS contacts your new ID or
undo the change (page 28).
2. You have not activated your mailbox.
¥
Activate your mailbox (page 28).
3. Call diversion is activated with
Calls or the call diversion
activated for the network mailbox.
¥
Change your call diversion.
When: All
All Calls is