Table of Contents
Advertisement
TROUBLESHOOTING
PROBLEM
No Power
Cannot Receive Messages
Range is Short
Interference/Static
Cannot
communicate
other models of FRS or
GMRS radios.
Radio is not responding to
button presses
Display is dim
SOLUTION
1. Check battery installation and/or replace batteries
1. Make sure the volume is set high enough.
2. Confirm the radios have the same channel and or
CTCSS code settings.
3. Change your location, you may be out of range.
4. Install batteries properly or replace.
5. Buildings, obstructions, operating indoors or in
vehicles may interfere with communication.
Change your location.
6. Make sure the radio is not transmitting. This could
be due to accessories not set properly.
1. Operating the radio from a vehicle or from a metal
building will decrease the range. If possible operate
outside of vehicles or buildings.
2. Carrying the radio so that the antenna is very near
the body will decrease the range. Hold the radio in the
open for the best range.
3. Battery condition can affect range.
recharge batteries.
1. Using the CTCSS should stop you from hearing
interference from other users and computers.
2. Radios too close. Radios must be at least 5 feet
apart.
3. Radios too far apart. Obstacles interfere with
transmissions. Talk range is up to 5 miles in
unobstructed, clear areas.
with
1.Refer to channel frequency list on page 17 to confirm
that you are using the same frequency.
2. Refer to the CTCSS tone list on page 11 to confirm
that you are using the same tone code.
1. Make sure key lock is not on. See To lock the
controls
2. Make sure radio is not transmitting.
3. Radio might need to be reset, See Resetting Radio.
4. Ensure accessory microphone is set properly (see
Page 12).
1. Reposition or replace batteries.
14
Replace or
Advertisement
Table of Contents
