Troubleshooting - Midland G7XT Instruction Manual

To select the call tones:
1. Push the MENU [18] button seven times until the display shows "CA 1".
2. Using the scroll buttons
3. To confirm the roger beep activation, press PTT [12] button or wait
for 5 seconds.
Now, each time your Midland G7XT sends out a tone call, it will beep with the selected
melody.
6.8 Dual Watch Function
This function allows the monitoring of 2 channels of your choice.
1. Select 1 of the 2 channels to be monitored.
2. Press the MENU [18] button 9 times, until the display shows "TX oF RX".
3. With the
4. Push the PTT [12] key or wait 5 seconds.
6.9 Keypad Beep
To deactivate the keypad beep, follow these steps:
1. Press the MENU [18] button 8 times until "bP on" is displayed
2. Use the
3. Confirm by pushing the PTT [12] or wait for 5 seconds.

7. TROUBLESHOOTING

Your Midland G7XT is designed to provide years of optimal performance. If problems
arise, reset the device before contacting the service centre in your region.
7.1 Reset
If the tranceiver freezes or experiences a logic error (improper symbols on the display,
blocking of functions, etc.) it may not be defective. Rather, the problem may be caused
by external factors like noise or a spike in the electrcal system while charging. In such
cases, reset the transciever to its factory-programmed settings:
1. Turn off the transciever.
2. Remove the batteries for about 60 seconds
Note: Before resetting we recommend that you take note of all personal settings since
these may be deleted during the reset process.
8. Repeater Functions
Channels marked Duplex are reserved for repeater use in some areas. These are paired
with higher channels as output/input (1/31, 2/32, etc). To avoid interference check for
local repeater activity before using these channels in Simplex mode. Your radio has a
Repeater Access function to allow use of local Repeater stations (if available in your
area). Repeaters are shared radio systems installed by interested parties (clubs, local
businesses etc.) that pick up transmissions on specific channels and re-transmit (or re-
peat) the received signal to another channel. You may access the repeater if it is within
range. The repeater RECEIVE channels are 1 - 8 , 41 - 48 and TRANSMIT channels
31-38 and 71-78.
[20] select "on" and "rb oF";
[20] button, select the second channel to monitor.
[20] buttons until the display shows "bP of".
10