BellSouth 100 Instruction Manual page 5

B E L L S O U T H 1 0 0
T M
I N S T R U C T I O N M A N U A L

Do not pull on the power cord at any time during incubation or
to disconnect. Unplug directly using plug when disconnecting.
Supervise your egg incubator when it is turned on or incubating
and check regularly, daily.

Fitting of any parts should be undertaken by a qualified
electrician. Isolate incubator from power supply before
investigating issues or performing routine maintenance.
Always use egg incubator on a level surface and keep away from
ledges.
!
Do not turn the egg incubator upside down at any time.
Caution: Some reports have come to hand of erratic performance
of Bellsouth incubators with solar and inverters. These have been
caused by over-voltage and spurious emissions from non-sine
wave inverters. Have an electrician test over-voltage and spurious
!
emissions. Use on a circuit with a continuous base load.
This egg incubator is not intended for use by persons (including
children) with reduced physical, sensory, or mental capabilities, or
people unfamiliar with these instructions, or lack of experience or
knowledge, to operate, clean, or maintain the egg incubator.
!
Do not cover the egg incubator with a towel or blanket if
temperature is low or if there is a power loss.
Do not misuse, sit on or stand on the egg incubator.
The thermometer has glass containing enclosed red paraffin spirit.
!
Handle with care; do not drop or break. If broken dispose of
carefully.
Do not place the egg incubator into wet, humid or moist
environments.
Do not remove labels from egg incubator.
!
Tip: Recommend using with a quality power surge protector.
Bayale Pty Ltd trading as Bellsouth
ABN 54 895 116 137, ACN 154 912 839. Address: 5/22 Carter Way, Dandenong South VIC
E G G I N C U B A T O R
TM
manufacturer and supplier of Bellsouth
Australia.
4
TM
egg incubator.