Table of Contents
Advertisement
f.
Place the thermostat sensor just above the top of the eggs (approx 1-3mm above).
g.
Place the top (lid) part of the polystyrene casing onto the bottom (base) part of the
polystyrene casing so the lid and base fit well together.
h.
Plug in the incubator to a surge protector portable 240V Australian power point
before placing eggs in incubator. Once plugged in, the lamp on the electronic
thermostat will turn on. Ensure the egg incubator reaches desired temperature of
103 degrees Fahrenheit and stabilises (for about an hour) before adding eggs to
incubator.
Please note if your room is colder than operating conditions allow then incubator
will not start and the light will not illuminate.
Using a good quality power point with surge protection and using an uninterrupted
power supply (UPS) will assist in protecting your incubator from power spikes and
brown outs.
i.
The lamp on the electronic thermostat will flash continuously when the
power is on. The lamp indicates the element is heating. When the lamp is
off, this indicates that the thermostat is not causing the heating element to
heat.
j.
If the egg incubator does not reach desired temperature of 103 degrees
Fahrenheit, use the temperature control knob located on top of the
incubator to make an adjustment. Please note that a small quarter turn will
change the temperature by several degrees so the adjustments are to be
incremental. Allow at least 20 minutes between adjustments.
Bayale Pty Ltd trading as Bellsouth
incubator.
ABN 54 895 116 137, CAN 154 912 839. Address: 5/22 Carter Way, Dandenong
TM
manufacturer and supplier of Bellsouth
South VIC Australia.
9
TM
egg
Hide quick links:
Advertisement
Table of Contents
