Index - BellSouth 100 Instruction Manual

Index

TM
Bellsouth Incubator 100
incubator, eggs are to be turned by hand only as there is no turner.
Bellsouth TM Incubator 100
the external push/pull rod so there is no need to open the incubator for turning.
Bellsouth TM Incubator 100
100 egg incubator, eggs are turned approximately 1.5 hours when turner is installed
and plugged in.
Black bungs are in side ventilation holes and may be removed for more ventilation.
Heating element is located on underside of top of the polystyrene casing and
creates heat in incubator in response to thermostat.
Flat U shaped metal clip holds the perforated metal floor and plastic frame
together at the auto turner end.
Indicator lamp is a light next to sensor protruding from thermostat and is visible
through viewing port
Motor test control knob controls how far the eggs turn in the auto turner (and how
far the plastic tray will travel).
Perforated metal floor is the metal floor that sits in polystyrene base of egg
incubator
Plastic mini funnel allows filling of a water channel through the two round holes (a
hole for each channel) in the plastic floor.
Plastic floor for manual or semi-auto turner that sits in plastic frame above the
perforated metal floor.
Plastic dividers sit in the plastic frame above plastic floor.
Push/pull rod for the semi auto turner will fit through a ventilation hole and attach
to the plastic floor.
Bayale Pty Ltd trading as Bellsouth
incubator.
ABN 54 895 116 137, CAN 154 912 839. Address: 5/22 Carter Way, Dandenong
Manual
type: This model of the Bellsouth 100 egg
Semi auto turner
type: The eggs are to be turned by
automatic turner
type: This model of the Bellsouth
TM
manufacturer and supplier of Bellsouth
South VIC Australia.
20
TM
egg