BellSouth 100 Instruction Manual page 17


perforated metal floor. The curved section of the clip should be to the top.
Slide the clip on until the back of the clip is against the end piece.
g. Place the perforated metal floor and assembled frame into the incubator
base.
h. Remove black bung from the turner end of the incubator base to allow the
auto turner power cord through (see photo showing path with white line)
If eggs roll up over each other, place blunt ends together and pointy ends
together.
Bayale Pty Ltd trading as Bellsouth
incubator.
ABN 54 895 116 137, CAN 154 912 839. Address: 5/22 Carter Way, Dandenong
i. Place the tray into the turner frame with the gear
teeth under the motor. Lift the motor slightly to slide the
tray into place.
j. Check the motor is engaged in the gear and plug in
the automatic turner power pack and cord. Plug the
power pack into a good quality surge protector 240 volt
power socket and switch on the power point.
k. Pressing the test button will cause the motor to run
until it reaches its limit. Once started it will run and turn
automatically approximately every 1.5 hours. The turning
motor test control knob controls how far the eggs turn
(and how far the plastic tray will travel). Smaller eggs such
as quail eggs may require a smaller egg turn.
l. Place the first plastic divider near the motor end.
Place a row of eggs on the tray and place a second plastic
divider in place. Ensure the plastic dividers allow several
millimetres clearance of the eggs. If the eggs touch both
dividers at the same time they will skid and not roll over.
Too many eggs in each row may make the eggs bind on
each other. Fill the tray with rows making sure the rows are
parallel.
TM
manufacturer and supplier of Bellsouth
South VIC Australia.
16
TM
egg