State and Federal standards instructions and safety precautions for the installation of in your area. Anthony Liftgates offers a bolt-on the ETU TuckUnder™ liftgates. bumper, which meets the requirements of this standard.
COULD result in death or serious to prevent injury or even death. injury. Anthony Liftgates cannot anticipate every possible Indicates a potentially hazardous circumstance that might involve a potential hazard. The CAUTION...
This list may include, but is not lowering of the liftgate can cause severe crushing limited to: injuries. • A hard hat. • Protective shoes with slip-resistant soles. • Protective goggles, glasses, or face shield. • Protective clothing. Anthony Liftgates, Inc. ETU Maintenance www.anthonyliftgates.com 800-482-0003...
Anthony Liftgates will not platform. Always stand away from the edge. When on accept responsibility for damages as a result of using the ground, always stand clear of the liftgate when it unapproved parts.
12. Examine all warning, capacity, and operational decals. If they are not readable, replace them. Decals may be obtained free of charge your authorized dealer. 3.2 Semi-Annual Inspection In addition to the items requiring monthly inspection, also Anthony Liftgates, Inc. ETU Maintenance www.anthonyliftgates.com 800-482-0003...
(arrows shown in Step 2) between the cam plates and platform. 4. If the platform does not align with the floor extension, contact Anthony Liftgates for a solution to correct the problem. 3.4 Hydraulic System Maintenance 3.4.1 Adding Fluid to Power Unit Reservoir 1.
T-fitting and pressure gauge. 1. While installed in the pump, remove nut (1). 2. Remove coil (2) from cartridge (3). 3. Remove cartridge (3) from pump body. 4. Replace O-rings (4). Anthony Liftgates, Inc. ETU Maintenance www.anthonyliftgates.com 800-482-0003...
1. Disconnect the power cable from the battery. 2. Cut and remove the heat shrink tubing covering the fuse. ETU Maintenance Anthony Liftgates, Inc. 800-482-0003 www.anthonyliftgates.com...
7. Reconnect the power cable to the battery after you are certain liftgate area is clear. Note: If the fuse continues to blow, contact your authorized dealer. 4. Decals Anthony Liftgates, Inc. ETU Maintenance www.anthonyliftgates.com 800-482-0003...
Do not allow body parts to contact moving components. • Ensure footing is stable and stand away from edge • before raising or lowering platform. A-131028 Owner/operators must properly maintain liftgate. • A-131115 ETU Maintenance Anthony Liftgates, Inc. 800-482-0003 www.anthonyliftgates.com...
Page 14
Do not put a higher rated decal on a liftgate with a lower capacity; this could result in liftgate damage or possibly personal injury. Anthony Liftgates, Inc. ETU Maintenance www.anthonyliftgates.com 800-482-0003...
Page 15
A-150601 7 — A-131147 8 — A-131148 9 — A-131133 This hydraulic reservoir is filled with Kendall Glacial Blu hydraulic fluid. Use ONLY the same or equivalent fluid. A-131133 10 — A-131028 A-131028 ETU Maintenance Anthony Liftgates, Inc. 800-482-0003 www.anthonyliftgates.com...
Remove the oil reservoir and make sure the return tube is below the oil level. If the tube has turned or fallen out, reinstall it into the pump housing. Use a center punch to “stake” the tube into position. Anthony Liftgates, Inc. ETU Maintenance www.anthonyliftgates.com 800-482-0003...
Page 17
Platform will not lower. Platform operating area is not clear. Clear area. Structural damage. Replace damaged parts. Low Voltage. Recharge battery (if less than 9 Volts). Hydraulic pump and motor. Replace power unit. ETU Maintenance Anthony Liftgates, Inc. 800-482-0003 www.anthonyliftgates.com...
Page 18
NOTES Anthony Liftgates, Inc. ETU Maintenance www.anthonyliftgates.com 800-482-0003...
Page 20
ANTHONY LIFTGATES, INC. 1037 W. HOWARD ST. • P.O. BOX 615 PONTIAC, IL 61764-0615 PH: 815-842-3383 FAX: 815-844-3612 TOLL FREE: 800-482-0003 WWW.ANTHONYLIFTGATES.COm Form No. L-901-MM (02-19) Este manual en español también está disponsible en nuestro sitio Web.
Need help?
Do you have a question about the ETU-20-44 and is the answer not in the manual?
Questions and answers