ResMed AirFit N20 Disinfection And Sterilization Manual

Disinfection and sterilization guide
This guide is intended for multipatient use of the AirFit N20 / AirFit N20 for Her ResMed nasal mask in a sleep lab, clinic or hospital. If you use the mask as a single user in the home, refer to the User
Guide for cleaning instructions. This guide describes ResMed's validated procedures for cleaning, disinfection and sterilization of the mask in accordance with ISO17664.
AirFit N20 / AirFit N20 for Her
mask component
1
Thermal water bath
• Cushion
• Magnetic clip
• Multi-hole elbow and short tube
3
• Frame / headgear
1 This mask may not be available in all regions. For full details regarding the correct use of this mask, please refer to the specific User Guide.
2 If a healthcare facility requires an additional disinfection or sterilization cycle after reassembly, the number of validated cycles must be halved.
3 The multi-hole elbow and short tube are not separable.
1
High level thermal disinfection
Thermal water bath
194°F (90°C) 199.4-203°F (93-95°C)
for 1 min for 10 min
—
—
—
—
B C
A
2
7
3
4
5
High level chemical disinfection
CIDEX OPA STERRAD
™
Ortho-phthalaldehyde 0.55%
Short cycle
12 min soak (boosters not required)
—
—
—
A
1
D
2
3
4
5
B
C
D
6
7
8
A+B+C
6 8
A+B+C+D
Clinical use only
Sterilization
100S STERRAD NX
™ ™
Standard or
advanced cycle
— —
— —
— —
Multi-hole elbow and short tube
Elbow
Side buttons
Vent
Short tube
Swivel
Frame
Cushion
Headgear
Magnetic clips
Lower headgear straps
Upper headgear straps
Frame system
Complete system
Validated number of
cycles
2
30
English 1