Table of Contents
Advertisement
2.5 CONNECTING DC POWER TO THE BASE
1. From the customer supplied 12 VDC power supply, run the red and black 12V DC power wires through one
of the strain reliefs in the side of the base. Ensure the cables are at least AWG 12 and no longer than 50ft
from the power supply to the base board.
2. Locate terminal block TB3.
TP-4976401-C
October 2018
Figure 2-1
INFLEXION 4.5 Mounting Hole Pattern Shown
See section 1.4 for other hole patterns.
TM
INFLEXION
2-6
Advertisement
Table of Contents
