Mast Load; Power Requirements; Figure 1-2 Inflexion 4.5 Model Number 722069001 Dimensions - Will Burt INFLEXION 2.3 Installation, Operation & Maintenance Manual

1.5 MAST LOAD

It is important that the mast be securely mounted to a sturdy platform, which will not overturn during operational loading
of the mast. Following is the loading information for the mast, which can be expected during operation:

75 lb at saddle of mast (Inflexion 1.5 and 2.3) or 120 lb saddle of mast (Inflexion 3.0, 4.5, 6.0, and 7.5)

200 lb at the front of the base cover

575 lb at rear of base cover (mast pivot)

1.6 POWER REQUIREMENTS

DC power for the INFLEXION is supplied by the vehicle and customer-wired to the mast base board. The INFLEXION
operates at 12 VDC, but will accept 24 VDC with the optional 24/12 converter. The DC cables should be 12 gauge (for
12V) and 16 gauge (for 24V). Long runs of cable can introduce power loss. There is a 35-40 amp inrush to the motor
(depending on the length and gauge of the wires) that drops to 6-7 amps in 300mS. For long runs, it may be necessary
to increase the wire gauge of the cables. If required, the vehicle-integrator is responsible for installing an ON/OFF switch
to disconnect power from the unit. This switch should be in line with the positive power cable (from battery source). If
using a separate power supply, it should have a 10 amp minimum.
TP-4976401-C
October 2018

Figure 1-2 INFLEXION 4.5 Model Number 722069001 Dimensions

TM
INFLEXION
1-3