Sony DSM-R1 Operating Manual page 13

Item number Item
41 OUT1 AUDIO CH
45 DEST ADDR-1
48 OUT1 V SETUP
49 OUT1 H-BLANK
51 OUT2 AUDIO CH
55 DEST ADDR-2
58 OUT2 V SETUP
59 OUT2 H-BLANK
81 LCD CONTRAST
82 LCD BACKLIGHT
91 SAVE BANK
92 RECALL BANK
93 FACTORY SET
Parameter Function
CH1/CH2
Selects the output audio signals from the 3-pin XLR
CH3/CH4
connectors on the BKSM-R103 Analog Output Board
in the OUT1 section of the unit. This item does not
appear when 5-pin XLR connectors are used.
0000
Sets a destination address If the BKSM-R101 SDTI
0000···FFFF
Output Board is installed in the OUT1 section of the
unit.
0.0%···7.5%···10.0%
Sets the VIDEO SETUP volume to be added to the
output signals when the BKSM-R103 Analog Output
Board is installed in the OUT1 section of the unit.
Selects from 0.0% to 10.0% in 0.5% steps. The
parameter should be the same as that of the IN1 V
SETUP of DSM-T1 menu.
This is applicable to NTSC video signals. For PAL,
only 0.0% can be selected.
NARROW WIDTH
Selects the horizontal blanking width of the output
WIDE WIDTH
signals when the BKSM-R103 Analog Output Board is
installed in the OUT1 section of the unit.
CH1/CH2
Selects the output audio signals from the 3-pin XLR
CH3/CH4
connectors on the BKSM-R103 Analog Output Board
in the OUT2 section of the unit. This item does not
appear when 5-pin XLR connectors are used.
0000
Sets a destination address if the BKSM-R101 SDTI
0000···FFFF
Output Board is installed in the OUT2 section of the
unit.
0.0%···7.5%···10.0%
Sets the VIDEO SETUP volume to be added to the
output signals when the BKSM-R103 Analog Output
Board is installed in the OUT2 section of the unit.
Selects from 0.0% to 10.0% in 0.5% steps. The
parameter should be the same as that of the IN2 V
SETUP of DSM-T1 menu.
This is applicable to NTSC video signals. For PAL,
only 0.0% can be selected.
NARROW WIDTH
Selects the horizontal blanking width of the output
WIDE WIDTH
signal when the BKSM-R103 Analog Output Board is
installed in the OUT2 section of the unit.
1···5···10
Adjusts the contrast of the display window.
1···5···10
Adjusts the brightness of the display window back
lighting.
1···8
Selects the menu bank in which the parameters in the
current bank are to be saved.
1···8
Selects the menu bank in which the parameters to be
recalled are saved.
---
Resets the parameters in the current bank to the
factory setting.
13