Siemens 4100 Series User Manual page 11

Residential Gateway Family User Guide
USB Installation Method (Microsoft Windows)
2. Connect the DSL Cable
1) Connect the DSL cable (resembles a telephone cord) to the DSL port on the Router.
2) Plug the other end of the DSL cable into the phone jack.
3. Connect the Power
1) Connect the power adapter to the rear of the Router.
2) Plug the power adapter into the electrical wall outlet.
3) Flip the power switch to power on the Router.
4) Power on all connected computers.
4. Install USB Driver Software
1) Insert the USB driver CD-ROM into the CD-ROM drive of your computer.
2) When prompted, follow the on-screen instructions to complete the driver installation.
5. Check the LEDs
1) The DSL, USB, and Power LEDs should be lit.
You can now configure the TCP/IP settings as detailed in
USB Driver Installation (Macintosh Systems)
When using the USB installation method on a Macintosh, follow these steps to install the USB drivers:
1.
Insert the SpeedStream Installation CD into your CD-Rom drive.
2.
Open the SpeedStream icon from the desktop.
3.
Click Readme.txt to open it.
4.
Follow the directions in the Readme.txt file.
You can now configure the TCP/IP settings as detailed in
.
1. Connect the USB Cable
1) With your computer off, connect the provided USB cable to
the USB port on the Router.
2) Connect the other end of the USB cable to an open USB
port on your computer.
3) If desired, use standard 10/100 CAT5 Ethernet cables to
connect additional computers to the Ethernet ports on the
Router.
Chapter 3, Operating System
Chapter 3, Operating System
8
Installation
Configuration.
Configuration.