Putting Your Water Computer Out Of Operation; Maintenance; Clean Filter - Gardena C 1060 plus Operating Instructions Manual

Reset :
Important information :

6. Putting Your Water Computer out of Operation

Storage /
Overwintering :
Disposal :
(in accordance with
RL 2002 / 96 / EC)
Disposing of flat batteries :

7. Maintenance

Clean filter :

H
N
I
14
The factory settings are restored.
v Press Man.-key and Menu-key simultaneously for 3 seconds.
All the LCD symbols are displayed for 2 seconds and the
display moves to the normal display.
• All the program data are set to zero.
• The manual watering period is set to
• The language, the time and the day of the week are retained.
If no entry is made during programming for a period of more than
60 seconds, the normal display reappears. In this case all changes
made up till now will be applied.
When a sensor installed in the Water Computer registers damp
(OFF), the programmed watering is not carried out. There must
be a 1 minute pause between programs.
1. Press Menu-key 3 times, select Prog
button and confirm with the OK-key.
The watering program is not run.
2. Store your Water Computer in a dry place where it is protected
from frost.
The product must not be added to normal household waste. It
must be disposed of in line with local environmental regulations.
v Important : Make sure that the unit is disposed of via your
municipal recycling collection centre.
v Please return flat batteries to a GARDENA dealer or dispose
of them properly at your nearest recycling centre.
Only dispose of batteries when they are flat.
N
The filter should be checked regularly and cleaned when
necessary.
1. Unscrew sleeve nut
from the tap thread (do not use pliers).
2. If necessary unscrew the adaptor
N
3. Remove filter from sleeve nut
4. Fit the Water Computer again (see 4. Putting Your Water
Computer into Operation "Connecting Water Computer" ).
0 0 : : 3 3 0 0
again.
O O F F F F
I
of the Water Computer by hand
H
.
I
and clean.
with the rotary