Setting Up The Handset For Use - Siemens Gigaset E450 User Manual

First Steps
Please note:
u
The power adapter must be always
connected, as the phone will not oper-
ate without an electrical connection.

Setting up the handset for use

Fitting the battery pack
Caution:
Use only the rechargeable battery pack recom-
mended by Siemens (page 31). Never use a
conventional (non-rechargeable) battery pack,
as this may cause significant damage to health
and property. For example, the outer casing of
the battery pack could be destroyed or the bat-
tery pack could explode. The phone could also
malfunction or be damaged as a result of using
batteries that are not of the recommended
type. Use of battery packs not authorized by
Siemens may void the warranty on this prod-
uct.
¤
Insert the plug into the socket as shown
in the enlarged view.
¤
Insert the battery pack.
¤
Place the cords in the cord routing.
6
Closing the battery cover
¤
Hold the battery cover at a slight angle
and install the two lower clips into the
casing first. Then close the cover, press
on the top so that it clicks into place.
Locking the battery cover
Insert the catches on the lock ring or belt
clip into the notches in the casing and
make sure that the arrow markings on the
casing are facing those on the bottom of
the ring. Turn the lock ring or belt clip
clockwise to the end stop. When both
holes are horizontally aligned with the
upper edge of the handset the lock ring is
closed.