Table of Contents
Advertisement
Opening the battery cover
Position both thumbs on the lock ring and
simultaneously turn the lock ring or belt
clip anticlockwise and remove.
¤
Insert a coin into the cavity at the top of
the battery cover and twist it until the
cover opens.
Placing the handset in the base station
and registering
¤
Place the handset in the base with its
display facing outwards.
The handset registers automatically. Reg-
istration takes around 1 minute. During
this time
Regstr.Procedure
display and the name of the base station
flashes, for example
will be assigned the lowest unassigned
internal intercom number (1–6).
This will appear in the display when regis-
tration is complete, for example
This means that the number 1 has been
assigned. If the internal numbers 1–6
are already assigned to other units, the
number 6 is overwritten.
Notes:
– Automatic registration is only possible if
no-one is making calls using the base sta-
tion.
– Each key press interrupts the automatic
registration.
– If automatic registration does not work the
handset will need to be registered manually
(page 18).
– You can change the name of the handset
(page 21).
appears in the
1. The handset
Base
INT
1.
Leave the handset in the base station to
charge the battery pack.
Notes:
– If the handset has switched itself off
because the battery has no charge, and is
then placed in the base station, it will
switch itself on automatically.
– The handset must only be placed in the
designated base.
For questions and problems see page 30.
Headset socket
Which headsets are compatible?
The following headsets have been tested
with the S45:
u
Plantronics M40
u
Plantronics MX100
u
Plantronics MX150
If you do not connect a headset, please
insert the cover supplied for the headset
socket to support the splash proof feature.
Initial charging and discharging of the
battery pack
If the handset is activated, the flashing
battery icon e in the top right of the dis-
play indicates that the battery pack is
being charged.
During handset operation, the battery
icon indicates the charge status of the bat-
tery pack (page 1). The correct charge sta-
tus can only be displayed if the battery
pack is first fully charged and discharged.
¤
To do this, leave the handset in the
base station continuously for ten
hours. Your handset need not be
switched on for it to charge.
¤
Afterwards, remove the handset from
the base station and do not put it back
again until the battery pack is fully dis-
charged.
Note:
After the initial charge and discharge
you may replace your handset in the
base station after every call.
First Steps
7
- Quick Links:
- Setting up the Handset for Use
Hide quick links:
Advertisement
Table of Contents
