Host Commands - Allen-Bradley 1784-KTX Reference Manual

Chapter 4

Host Commands

4-2
Of the seven 1784-KTx host commands, five are scanner management
commands:
Set Mode
Set Scan List
Autoconfigure
Set Fault Group
Get Scan List
We describe these in detail, including command syntax, error codes, and
the confirmation process for that command.
The two remaining commands,
block-transfer commands, and are described in chapter 5.
Set Mode
Use the command to set the 1784-KTx scanner to one of three
Set Mode
modes: Program, Test, or Run.
In this mode the scanner
Initially the scanner is in Program mode and does not communicate on the
remote I/O link until it has a scan list.
Command Syntax
This command queues a confirmation immediately. The confirmation
looks like this:
Set Mode Confirmation
and
Host BT Write Host BT Read
, are