Adjusting The Height Of The Binding Units - Shimano SRD Assembling Manual

ROWING

(11) Adjusting the Height of the Binding Units

• Slide the Binding Units on the Frame Units to
set the height.
• The height of the center of the Virtual Pivot Th h i ht f th
axis(X) should be 0-3CM lower than the
height of the seat. The lowest point of the top
surface ,usually edge of the holes (X), should
be measured to check the height of the seat. b
© 2009 Shimano, Inc. ALL RIGHTS RESERVED
t f th Vi t
d t h k th h i ht f th
l Pi t
t
13