Adjusting The Stance - Shimano SRD Assembling Manual

ROWING

(9) Adjusting the Stance

Bolts to hold the Upper Pipe
fitting cramps(Only bolts on right
unit is shown)
• L Loosen the bolts shown by green arrows a little. You
can set the stance width by moving Frame Unit
sideways.
• You should slide the binding units up and down on
the Frame Unit to have the access to those bolts. the Frame Unit to have the access to those bolts
CAUTION: Do not loosen those bolts too much,
otherwise the binding unit may slide down and hit
the hull to result in the serious damage to the hull.
• When you try to make the stance wider, go through
procedure (8)again to make sure there is the enough
space.
• If you are setting SRD Footstretcher on the single
scull, we recommend to have the stance as wide as
the space against the hull allows. the space against the hull allows
Bolts to hold the Lower
Pipe fitting cramps
© 2009 Shimano, Inc. ALL RIGHTS RESERVED
pp p
th b lt h b
y y
littl Y
, g g
11