Menus; Phonebook; How To Add Phonebook - VACOM WIRELESS, INC VC-7C Operating Manual

I. Phone Book

1. How to add Phonebook

To add a phone number in Phonebook, press "MENU" and "1. PB Add".
- Then you can see an image of the phone and UIM on the display. Select one of them
to store or edit.
- Choose a type of the phone number among the image of a mobile phone, Home,
Office and etc by scrolling "
- Once you choose a type of the phone number, press "EDIT" and enter the name.
Press "OK" to save the name.
- Scroll " /
- Enter the location and phone number and press "OK" to save.
If you want to add "Group", "e-mail address", "memo" or "bell type" for CID incoming rings,
scroll " " before you press "OK".
- "Group" : Scroll "
Group, refer to "4. Group Editing" below).
- "E-mail" : Press "EDIT" and enter the e-mail address. Press "OK" to finish.
- "Memo" : Press "EDIT" and write a memo. Press "OK" to finish. (how to write a
memo, refer to "ENTERING LETTERS & NUMBERS" on page ___.
- "CID Incoming Ring" : If you are registered CID service and if you want to set a
distinctive ringing when you receive this phone number, scroll "
the incoming bell type.
- Once you finished to set all the information for Phone book, press "OK" to store.
- Then you can see a total number of used and empty locations and a message that the
number you wanted to store was stored successfully. And it goes to stand-by mode.
Note ) If you want to store the number in UIM, press "Menu" and "1. PB Add" and choose

MENUS

".
" to edit the location number and the phone number.
" to choose a group type if you added a group. (how to add
17
" to choose