Battery Information - VACOM WIRELESS, INC VC-7C Operating Manual

BATTERY INFORMATION

Your phone comes with a partially charged, rechargeable Li-ion battery so that you can use the
phone immediately after it is activated.
Installing the Battery.
To attach the battery to your phone :
1. Hold the battery so that metal contacts on the base of the battery line up with the metal
contacts on the base of the phone.
2. Place the battery on the back of the phone with the top of the battery about a quarter of an
inch from the latch.
3. Gently slide the battery toward the top of the phone until it snaps into place.
Charging the Battery.
You can tell whether or not your battery needs to be recharged by checking the upper-right
corner of your phone's display.
When the battery charge level gets low, the battery sensor will let you know by blinking the
battery icon and making audible warning tone. If the battery level gets too low, the phone will
be turned off automatically. When this happens while you were receiving incoming call or
making outgoing call, the call will be automatically disconnected. Watch the battery strength
icon and make sure your battery is adequately charged to avoid such situation.
Charging with the Travel Charger.
Use traveler 's charges approved by Compal Electronics only. Using any other unauthorized
accessories may be dangerous and will invalidate the phone warranty if said accessories caused
damage or defected the phone.
To charge the battery using the Travel Charger :
- Plug the power cord of the charger into a wall outlet.
- Insert the connector of the charger at the bottom of the phone
(Note) Be sure that you put the connector of the charger into the phone correctly. Failure
12