VACOM WIRELESS, INC VC-7C Operating Manual page 13

to do so may causes damages to the phone.
A completely discharged standard battery recharges fully in approximately tbd hours. The
extended battery recharges in approximately tbd hours. Leaving your phone turned on during
charging, or charging batteries simultaneously, will increase charging time. Leaving the battery
in the charger once it is fully charged does not harm the battery.
Turning your phone on and off.
When you're ready to turn your phone on, press and hold "END/ " until the LED comes on.
When the phone has found a signal, the " " icon appears. Once the phone is on, it enters
Standby mode, which is the phone's idle state. You can make and receive calls now. After the
phone goes to Standby mode, you have to enter the PIN1 password to install your UIM to the
phone. For more information, please refer to "Turning your phone on" on page __.
To turn your phone off, press and hold "END/ " until the LED comes on, then the display will
go blank. When the phone is turned off, nothing is displayed on the screen.
Note : If "END/ " is pressed for less than one second, the phone will not turn off. This helps
your phone from being turned off accidentally.
Standby mode.
Standby is the most basic state of your phone. The phone goe s into standby mode soon after you
turn it on, or whenever you briefly press "END/ ". When your phone is in Standby mode, you
will typically see the banner (that's the message displayed when you turn on your phone). If you
enter a phone number, you can press "SEND" to dial it, or press "STO ( )"to save it in the
internal phone book.
Conversation Mode.
You can place and answer calls only when your phone is powered on. During a call, the phone is
in Conversation mode.
13