General Safety Information; Setting Up The Device; Repairs - Philips Screeneo HDP2510 User Manual

1 General safety information

Do not make any changes or settings that are
not described in this user manual. Physical
injury or damage to the device or loss of data
can result from improper handling. Take note of
all warning and safety notes indicated.

Setting up the device

The device is for indoor use only. The device
should be placed securely on a stable, flat sur-
face. Position all cables in such a way that no
one will stumble on them, thus avoiding possi-
ble injuries to persons or damage to the device
itself.
Do not plug in the device in moist rooms. Never
touch the mains cable or the mains connection
with wet hands.
Never operate the projector immediately after
moving it from a cold location to a hot location.
When the device is exposed to such a change in
temperature, moisture may condense on the
crucial internal parts.
The device must have sufficient ventilation and
may not be covered. Do not put your device in
closed cabinets or boxes.
Do not place the device on soft surfaces such
as tablecloths or carpets and do not cover the
ventilation slits. Otherwise the device could
overheat or catch fire.
Protect the device against direct sunlight, heat,
large temperature fluctuations and moisture.
Do not place the device in the vicinity of heaters
or air conditioners. Observe the information on
temperature and humidity in the technical data
(see Technical data, page 33).
Do not allow liquids to enter into the device.
Switch off the device and disconnect it from the
mains supply if liquids or foreign substances
end up inside the device. Have the unit
inspected by a technical service centre.
Always handle the device with care. Avoid
touching the lens. Never place heavy or sharp
objects on the device or the power cable.
If the device gets too hot or emits smoke, shut it
down immediately and unplug the power cable.
Arrange for your device to be investigated by a
technical service centre. To prevent the spread
of fire, open flames should be kept away from
the device.
4
Under the following conditions, a layer of mois-
ture can appear inside the device which can
lead to malfunctions:
• if the device is moved from a cold to a
warm area;
• after a cold room is heated;
• when this device is placed in a damp
room.
Proceed as follows to avoid any moisture build-
up:
1 Seal this device in a plastic bag before
moving it to another room, in order for it to
adapt to room conditions.
2 Wait one to two hours before you take the
device out of the plastic bag.
The device should not be used in a very dusty
environment. Dust particles and other foreign
objects may damage the unit.
Do not expose the device to extreme vibrations. It
may damage the internal components.
Do not allow children to handle the device
without supervision. The packing materials
should be kept out of the hands of children.

Repairs

Do not repair the device yourself. Improper
maintenance can result in injuries or damage to
the device. Your device must be repaired by an
authorised service centre.
Find details of authorised service centres on
the warranty card.
Do not remove the type label from your device;
this would void the warranty.
Philips · HDP2510