Philips Screeneo HDP2510 User Manual page 30

CAUTION!
• Do not turn the power on while the
lamp cover is removed.
• Do not insert your fingers between
the lamp and the projector.
• The sharp edges inside the projec-
tor may cause injuries.
1 Loosen the two screws that secure the lamp.
1 Pull out the lamp an den beiden
Aussparungen
.
CAUTION!
• Pulling it too quickly may cause the
lamp to break and scatter broken
glass in the projector.
• Do not place the lamp in locations
where water might splash on it,
children can reach it, or near flam-
mable materials.
• Do not insert your hands into the
projector after
removed.
• If you touch the optical compo-
nents inside, it could cause colour
unevenness and distortion of the
projected images.
30
2 Gentlly insert the new lamp.If it does´t fit eas-
ily, make sure it´s facing the correct way.
3 Tighten the two screws that secure the lamp.
4 Replace the lamp cover on the projector.
5 Tighten the two screws that secure the lamp
cover.
6 Plug the power cable to outlet.
Resetting the lamp timer
1 To turn on the projector, press once the B
button on the panel control of the device or
on the remote control.
2 Press the OPTION button and use ¡/¢ to
select System.
3 Confirm with OK.
4 Use ¡/¢ to select Reset lamp timer.
5 Confirm with OK.
6 A message displays asking if you want to
reset the lamp timer. Confirm with OK. The
lamp time will be reset to "0".
the lamp is
CAUTION!
• Loose screw may cause a bad con-
nection, which could result mal-
function.
• Do not over tighten the screws.
CAUTION!
• Loose screw may cause a bad con-
nection, which could result mal-
function.
• Do not over tighten the screw.
CAUTION!
Do not reset the lamp timer if the lamp
has not been replaced as this could
cause damage.
Philips · HDP2510