Instant Pot Smart WiFi User Manual page 7

Getting Started
Remove & Install Anti-Block Shield
5
Remove: Grip lid and press firmly against side
of anti-block shield (pressing towards side of lid
and up) until it pops off prongs underneath.
Install: Place anti-block shield over prongs
and press down until it snaps into position.
Remove: Detach
silicone cap from float
valve and remove from
top. Do not discard.
While float valve is up, contents of cooker are pressurized. Do not attempt to remove lid. Refer to "Venting
CAUTION
Methods" for releasing pressure.
Remove & Clean Inner Pot
8
Remove inner pot from cooker base and
wash before first use. Wipe outer surfaces
of inner pot and heating element to
ensure they are dry and free of debris.
Do not pour food or liquid into cooker base. To avoid risk of personal injury and/or property damage, always
CAUTION
cook in inner pot.
Remove & Install Float Valve & Silicone Cap
7
Install: Drop float valve into
top. Attach silicone cap to
bottom of float valve.
Secure detachable power cord to
base power socket. Connect to a 120V
power source. Cooker will display
"OFF" to indicate Standby mode.
Check Sealing
6
Ring & Sealing Ring Rack
Remove: Pull sealing ring out from
behind sealing ring rack.
Install: Place sealing ring over sealing ring rack
and press into place. Ensure sealing ring is snug.
Down: Cooker is
depressurized
Secure Power Cord
9
To disconnect, press Cancel then
remove plug from power source.
Up: Cooker is
pressurized
7