Service Parts; Warranty - Ortech ODS-8003-14 Manual

INSTALL GRILLE
Install ceiling material to complete the ceiling construction. Then, cut around
the fan housing.
To attach the grille assembly to the fan housing, pinch the grille springs on
the sides of the grille assembly, and position the grille into the housing with
the grille springs in the appropriate slots. Push the grille assembly towards
the ceiling to secure.

SERVICE PARTS

PART PART NAME
1 Grille Assembly (includes part 2)
2 Grille Spring
3 Humidity Sensor System (for sensor model)
4 Motor Plate
5 Motor
6 Blower Wheel
7
Wire Panel / Harness Assembly
8 Hanger Bar Kit (long)
9
Wiring plate
10
Housing
11 Hanger Bar Kit (short)
Damper / Duct Connector
12
a Nut, Hex Lock
b Washer
c Screw
d Isolator
e Screw
* Blower Assembly includes part 6, 5, d, 4, c, b, a.
Replacement installation:
Remove the screw (part c), then take out the motor plate (part 4) from
the housing (part 10) by pushing down the rib in the plate while pulling
out on the side of the housing. Replace the broken parts.
WARNING: Before replacing, be sure to turn off power at power source.

WARRANTY

ONE YEAR LIMITED WARRANTY from the original date of purchase against defects in material and workmanship.
This warranty is limited up to the amount of the original purchase price of the product, excluding any labor cost. For
inquiries please visit www.ortechindustries.com or call 1-888-543-6473.
Qty.
12
1
2
11
1
1
1
1
1
3
1
1
1
1
4
4
1
4
1
4
3
2
1
10
8
9
e
8
7
6
5
d
4
c
b
a