Rs232 Interface Cable To Td52Xw; Micro Sd Card Installation; Td52Xw Rear Housing Orientation; Mounting Bracket - OHAUS Defender 5000 TD52P Service Manual

1.7.3 RS232 Interface Cable to TD52XW

Pass the optional RS232 cable through the strain relief (Figure 1-2, item 10) and attach it to terminal block
J5 (Figure 1-3, item 7). Tighten the strain relief to maintain a watertight seal.

1.7.4 MICRO SD Card Installation

The SD memory card can be used for additional storage in the Checkweighing and Counting applications.
Figure 1-8 shows the installation of an SD card into the socket on the edge of the TD52P andTD52XW main
board.
Figure 1-8 Sliding an SD Card into the SD Socket (left); SD Card Installed (right)

1.8 TD52XW Rear Housing Orientation

The TD52XW is delivered in the wall mount orientation with the connections exiting below the display. The
rear housing may be reversed so the connections exit above the display when the TD52XW is placed
horizontally on a bench. To reverse the rear housing, remove the four Phillips head screws, carefully rotate
the housing 180° , and reinstall the screws.
Figure 1-9 Wall Mount Configuration Figure 1-10 Bench Top Configuration

1.9 Mounting Bracket

Attach the bracket to a wall or table using fasteners (not supplied) that are appropriate for the type of
mounting surface. The bracket will accommodate up to 6 mm (1/4") diameter screws. Locate the mounting
holes as shown in Figure 1-11.
10 Defender 5000 Indicators Service Manual