Wi-Fi Connections - LAUNCH TECH HTT User Manual

3. Press the [POWER] button for 2 seconds to turn it on. If the battery is
low, the [POWER] indicator blinks. In this case plug the included adaptor
into an outlet to charge it in time. While charging, the charge indicator
turns red. After charging is complete, the indicator will turn green. The
normal charging time is 2 hours.
Notes:
A. Please use the included DC adaptor and rechargeable battery only. We assume
no responsibilities for any personal injury or loss resulting from using other
adaptors or rechargeable batteries not specified in this user manual.
B. If the printer keeps unattended for a long period, please remove the rechargeable
battery.

8.4 Wi-Fi Connections

A. While used as a Wi-Fi peer-to-peer (P2P) printer, follow the steps
described below to make Wi-Fi connection:
Note: This mode configures the printer as an auxiliary equipment and only works
with Android diagnostic devices manufactured by LAUNCH.
1. Tap "Settings" on the home screen of e-VIN.
2. Tap "Wi-Fi" and slide its switch to ON.
3. Locate and tap the X-431PRINTER-XXX (XXX stands for 3 numbers).
4. Input the identity password (default factory value is 12345678) and tap
"Connect". "Connected" will appear on the screen once it is successful.
B. If used as a Wi-Fi hotspot printer, do the following to make Wi-Fi
connection and settings.
Note: This mode only applies to Wi-Fi LAN environment and works with e-VIN.
Vehicle VIN Checking Terminal
Fig. 8-7
29