Thermal Paper Loading - LAUNCH TECH HTT User Manual

1) Side lock notch
2) Paper outlet
3) POWER button: Press and hold it for 2 seconds to turn it on/off.
4) MODE (ready) button: Press it to get the printer ready or switch it to
manual feed mode.
5) FEED (paper test) button: Press it to test whether thermal paper is
properly installed while the MODE indicator goes out.
6) CHARGE indicator
[Green]: Indicates the battery is fully charged.
[Red]: Indicates it is charging.
7) DC 9V adaptor jack (Note: The USB port next to it is disabled. Do not
attempt to insert the cable into it.)
8) Rechargeable battery

8.2 Thermal paper loading

This Wi-Fi printer applies thermal paper roll with size of Φ30×57mm. Follow
the steps described as below to load it.
1. Hold the side notches on the front of the printer and lift it up to open the
cover.
2. Place the unpacked thermal paper into the compartment with its starting
end approaching to the paper outlet (refer to the figure shown as below).
Reversing paper direction will result in that no results will be printed
out.
3. Pull out some printing paper and introduce it along the slot until it comes
26
Vehicle VIN Checking Terminal
Fig. 8-2