Hatco GLO-RAY QW-6 Series Installation And Operating Manual
Hatco GLO-RAY QW-6 Series Installation And Operating Manual

Hatco GLO-RAY QW-6 Series Installation And Operating Manual

Que warmer
Hide thumbs Also See for GLO-RAY QW-6 Series:

Advertisement

Quick Links

Installation and Operating Manual
Do not operate this equipment unless you
have read and understood the contents of
this manual! Failure to follow the
instructions contained in this manual may
result in serious injury or death. This
manual
contains
information concerning the maintenance,
use, and operation of this product. If
you're unable to understand the contents
of this manual, please bring it to the
attention of your supervisor. Keep this
manual in a safe location for future
reference.
GLO-RAY
Que Warmer
QW-6 Series
I&W #07.05.128.00
important
safety
®
No opere este equipo al menos que haya
leído y comprendido el contenido de este
manual! Cualquier falla en el seguimiento
de las instrucciones contenidas en este
manual puede resultar en un serio lesión
o
muerte.
Este
importante información sobre seguridad
concerniente al mantenimiento, uso y
operación de este producto. Si usted no
puede entender el contenido de este
manual
por
favor
supervisor. Almacenar este manual en
una localización segura para la referencia
futura.
manual
contiene
pregunte
a
su
© 2008 Hatco Corporation

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GLO-RAY QW-6 Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Hatco GLO-RAY QW-6 Series

  • Page 1 Keep this supervisor. Almacenar este manual en manual in a safe location for future una localización segura para la referencia reference. futura. © 2008 Hatco Corporation...
  • Page 2: Table Of Contents

    Additional information can be found by visiting our web site at www.hatcocorp.com. INTRODUCTION The Hatco Glo-Ray Que Warmer is designed to hold Safety information that appears in this manual is melted, liquid, or soft food product such as butter, identified by the following signal word panels: syrup, gravy, and mashed potatoes at 170°F (77°C).
  • Page 3: Important Safety Information

    • DO NOT submerge or saturate with water. service is required on this unit, contact an Unit is not waterproof. Do not operate if unit Authorized Hatco Service Agent or contact the has been submerged or saturated with water. Hatco Service Department at 800-558-0607 or •...
  • Page 4: Model Description

    MODEL DESCRIPTION QW-6 Model The QW-6 Que Warmer is ideal for holding melted, liquid, or soft food products such as butter, syrup, gravy, and mashed potatoes at an even 170°F (77°C) temperature. The unit comes equipped with a built-in 1/6 size steam table pan, 6″ (152 mm) deep and constructed of sturdy stainless steel.
  • Page 5: Specifications

    WARNING ELECTRIC SHOCK HAZARD: Plug unit into a properly grounded electrical outlet of the correct NOTE: Receptacle not supplied by Hatco. voltage, size, and plug configuration. If the plug and receptacle do not match, contact a qualified Figure 3. Plug Configuration electrician to determine and install the proper voltage and size electrical outlet.
  • Page 6: Installation

    • Make sure all the feet on the bottom of the coverage, fill out and mail in the warranty unit positioned securely card to Hatco. countertop. 3. Remove tape and protective packaging from all surfaces of unit. WARNING FIRE HAZARD: Locate the unit a minimum of 1″...
  • Page 7: Maintenance

    MAINTENANCE General Cleaning The Hatco Que Warmer is designed for maximum To preserve the finish of the Glo-Ray Que Warmer, durability performance with minimum it is recommended that the surfaces be wiped daily maintenance. with a moist cloth. The built-in 1/6 size steam table pan should be washed using a clean damp cloth with mild soap and wiped clean with a damp cloth.
  • Page 8: Troubleshooting Guide

    Corrective Action Temperature control defective. Contact Authorized Service Unit too hot. Agent or Hatco for assistance. Unit not hot enough. Unit not on long enough. Allow unit to warm up for 15 – 20 minutes before placing product pan into unit.
  • Page 9 NOTES Form No. QWM-0208...
  • Page 10 NOTES Form No. QWM-0208...
  • Page 11: Hatco Limited Warranty

    PATENT OR OTHER INTELLECTUAL PROPERTY accordance with Hatco’s written instructions or 18 RIGHT INFRINGEMENT. Without limiting the months from the date of shipment from Hatco. Buyer generality of the foregoing, SUCH WARRANTIES must establish the product’s purchase date by DO NOT COVER: Coated incandescent light bulbs, returning Hatco’s Warranty Registration Card or by...
  • Page 12: Authorized Parts Distributors

    HATCO AUTHORIZED PARTS DISTRIBUTORS ALABAMA NEW YORK TEXAS IOWA Jones McLeod Appl. Svc. Acme American Repairs, Inc. GCS Service Electric Motor Service Co. Birmingham 205-251-0159 Brooklyn 718-456-6544 Fort Worth 817-831-0381 Davenport 319-323-1823 ARIZONA Alpro Service Co. Armstrong Repair Service Goodwin Tucker Group...

Table of Contents