Samsung AM***MNVD Series Installation Manual page 28

Setting an indoor unit address and installation option
Indication
Stopped
Default 90
(*5) When the following 2 or 3 is used as external heater On/Off signal, the signal for monitoring external contact control will not be output.
2: Fan is turned on continually when the external heater is turned on,
3: Fan is turned off when the external heater is turned on with cooling only indoor unit
Cooling only indoor unit: To use this option,install the Mode Select switch(MCM-C200) on the outdoor unit and fix it as cool mod.·
controller sensor to detect indoor temperature exactly.
(*6) When indoor unit is in cooling or Dry mode, The output signal is "ON".
Do not install the electronic heater
in the flow channel of the indoor unit fan.
05 series installation option
0 5
1 for mode change Cooling
→Heating
2 -
3 -
0 2 3
↔ ↔
160 100 160 110
Use of Auto Change Over or
cooling only for HR only
required for mode change
-
-
4 5
↔ ↔
160 120 160 130
Electronic heater should
not be installed.
Discharge side
Standard heating temp. Standard cooling temp.
Compensation option
indoor units
-
Forced FAN Operation
-
English-28
6 7 8
↔
160 160 200 250 300 400
Suction side
Air Flow
Duct Indoor unit
for mode change Heating →
MTFC (*3)
Control variables when using
-
hot water / external heater (*4)
for Heating and
Cooling
9 A
Cooling
-
-