Samsung AM***MNVD Series Installation Manual page 19

Extending the power cable
1 Prepare the following tools.
Tools
Crimping pliers
Connection sleeve [inch (mm)]
Insulation tape
Contraction tube [inch (mm)]
2 As shown in the figure, peel off the shields from the rubber and wire of the power cable.
Peel off 0.79 inch (20 mm) of cable shields from the pre-installed tube.
CAUTION
For information about the power cable specifications for indoor and outdoor units, refer to the installation manual.
After peeling off cable wires from the pre-installed tube, insert a contraction tube.
Power cable
20
0.79 (20)
7.09 (180)
Pre-installed tube for the power cable
Unit : inch (mm)
20
0.79 (20)
3 Insert both sides of core wire of the power cable into the connection sleeve.
Method 1: Push the core wire into the sleeve from both sides.
Method 2: Twist the wire cores together and push it into the sleeve.
Method 1
Connection sleeve
4 Using a crimping tool, compress the two points and flip it over and compress another two points in the same location.
The compression dimension should be 0.31 inch (8.0 mm).
Method 1
Compress it 4 times
0.20 inch
(5 mm)
20xØ0.26 (6.5) (HxOD)
Width 0.75 inch (19 mm)
20 20
0.79 (20)
0.79 (20)
60
2.36 (60)
120
4.72 (120)
180
Unit : inch (mm)
Method 2
Connection sleeve
Compression
dimension
Method 2
Compress it 4 times
0.20 inch
(5 mm)
English-19
Spec
MH-14
Shape