Table of Contents
Advertisement
2.
Try recycling power to the unit. The Access Point will try to contact an AP
Controller during boot-up. Therefore, if you are using the external AC power
supply, you should connect the Access Point to the Ethernet network before
turning on the unit.
3.
If neither of the above solves the problem, try to manually add the Access Point
as described in the Harmony Access Point Controller Model 7560 User's Manual.
Problem 2:
My Harmony 802.11 PC Card will not associate with the Harmony 802.11b Access
Point.
Solution 2:
Follow these steps if a PC Card cannot associate with the Access Point:
1.
Try to bring the devices closer together; the PC Card may be out of range of the
Access Point.
2.
Confirm that the Access Point and PC Card have the same ESSID.
3.
Confirm that the Access Point and PC Card have the same Encryption settings, if
enabled.
4.
Confirm that the Access Point's Status LED is on or use the Wireless Network
Management interface to confirm that it is partnered with an AP Controller. A
PC Card cannot associate with an Access Point unless the Access Point is
partnered with an AP Controller.
22
Advertisement
Table of Contents
