Operating Conditions; Power Consumption - Axis Q8685-LE Installation Manual

AXIS Q8685-LE PTZ Network Camera
NO NO TICE NO TICE TICE
• Use cables that keep within the specified cable area
• Select cables in compliance with your local regulations
• Make sure all cable holes are properly sealed
• Use cable gaskets or cable glands that match both the cable hole and the cable area
For information about accessories, such as cable gaskets and cable glands that allow for other
cable areas, see www.axis.com

Operating conditions

This Axis product is intended for indoor and outdoor use.
Temperature
Normal: -50 °C to 55 °C (-58 °F to 131 °F)
Maximum (intermittent): 65 °C (149 °F)
Cold start: -40 °C to 55 °C (-40 °F to 131 °F)

Power consumption

Typical consumption
Without illumination: 16 W
With illumination: 64 W
Important
When using the 22 m (72 ft) AXIS Cable 24 V DC/24–240 V AC, a power supply capable of
delivering 400 W is required to compensate for the power loss in the cable.
NO TICE TICE
NO NO TICE
The typical power consumption values are based on the following:
• Any losses in the power cable disregarded
• No positioning active
• No wiper motor active
• Temperature at 25 °C / 77 °F (all heaters off)
• One H.264 stream at maximum resolution
• MJPEG stream recorded to SD card
• IR lamps on 50% of the time (with illumination)
Humidity
10–100% RH (non-condensing)
Max consumption
Without illumination: 204 W
With illumination: 300 W
52