Troubleshooting - Bissell PROHEAT PET 8910 Series User Manual

Troubleshooting

Problem Possible causes
The heater switch is not turned
Heater ready
ON ( I ).
light does not
The machine power switch is not
illuminate
to turned ON ( I ).
Bladder may be empty.
Heater tank may be empty.
The filter may be clogged.
Reduced
Tanks may not be seated properly.
spray or
no spray
Pump may have lost prime.
The Pump belt may be broken.
The brush belt or pump belt is
off or broken.
DirtLifter®
PowerBrush
does not turn
WARNING
To reduce the risk of electric shock, turn power switch
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
Remedies
Turn ON ( I ) the heater switch.
Both switches must be ON ( I ) to
activate the heater ready light.
Refill bladder with hot tap water.
Fill with BISSELL Deep Cleaning
formula for cleaning. Fill with water
if rinsing.
Clean out flow indicator filter, page 13.
Turn power OFF (O); remove &
reseat tanks.
Turn power OFF (O); after 1 minute
turn ON and press trigger.
Turn on the machine and check to
see that the DirtLifter PowerBrush
turns. If it does not, refer to #1 below.
Turn the machine OFF (O) and unplug
from the outlet. To check if the brush
belt or pump belt has broken, you will
need a flat head screwdriver. Insert the
blade end into the lower slot of the
belt access door to release the lower
snap. If necessary, insert the blade
Lift Here
end into the upper slot to release
the upper snap. Examine the belt for
breakage. If broken, please refer to
Replacement Parts on page 17 before
calling Consumer Care. Complete
installation instructions will accom-
pany the replacement belt.
www.BISSELL.com
15