Bissell PROHEAT PET 8910 Series User Manual page 16

Troubleshooting
Problem
Cleaner
not picking
up solution
Please do
not return
this product
to the store.
www.BISSELL.com
16
Possible causes
ReadyTools dial may be on the
wrong setting for the cleaning job.
Nozzle window may not be
properly attached.
2-in-1 tank lid is not properly
installed.
2-in-1 tank is not properly seated. 2-in-1 tank must be firmly seated to
Poor tool position. (Hand held
attachments only).
2-in-1 Tank has picked up
maximum dirty water.
Other maintenance or service not included in the manual should
be performed by an authorized service representative.
Thank you for selecting a BISSELL product.
For any questions or concerns, BISSELL is happy to
be of service. Contact us directly at 1-800-237-7691.
WARNING
To reduce the risk of electric shock, turn power switch
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
Remedies
Set ReadyTools dial to either floor
cleaning or tools.
Press down firmly on the black oval
gasket at the top window to make
sure the two tabs on the back of the
nozzle window are snapped into the
mating slots in the main housing.
Re-install lid; refer to page 9.
function; remove and reseat 2-in-1 tank.
Adjust angle; apply more downward
pressure.
Empty 2-in-1 tank, refer to page 11.