Sony WRR-805A Operating Instructions Manual page 9

1 MONITOR connector
To monitor the audio output signal, connect the headphones
equipped with 3.5 mm dia. stereo mini jack. You can use
either of stereo or monaural headphones. The monitoring
level can be adjusted with the MONITOR control.
2 OUTPUT (BAL) connector
Supplies audio signals. You can connect this connector to
the microphone input connector of a Camcorder, mixer, or
tape recorder by using the supplied cable.
3 Display section
Shows the status of the tuner and the groups and channels
assigned to the unit.
A
C
A AF (audio frequency) indication
Lights when the output audio signal is over the reference
level.
B
D
B BATT (battery) indication
Displays the status of the batteries of this unit.
See "Battery indication" on page 11.
C RF (radio frequency) indications
The dot indications show the RF input level. Depending on
the RF input level, the number of dots changes as below.
Four dots on: more than 45 dBµ
Three dots on: between 35 dBµ and 45 dBµ
Two dots on: between 25 dBµ and 35 dBµ
One dot on: between 15 dBµ and 25 dBµ
No dot: less than 15 dBµ
D GP/CH (group/channel) indication
Shows the reception channel group and respective channel
number.
Each time you press the MODE button the group/channel
indication changes to the frequency and accumulated time
indications as shown below.
Group/channel
indication
Accumulated time indication
Frequency indication
9