Resetting The Accumulated Time Indication - Sony WRR-805A Operating Instructions Manual

Settings
Notes
•
Do not remove the batteries during group and wireless
channel selection. If they are inadvertently removed, re-
insert them immediately and repeat the steps on pages 12
to 13 from the beginning.
•
Make sure that the channel selected is the same as that
selected on the transmitter used in the same system.
•
Depending on the noise or interference conditions, the
selectable channels may not necessarily all be usable. If
necessary, you can determine the usable channels by
stepping the channel selection through a number of
channels on the tuner with the microphone/transmitter set
to OFF. Those channels on which the RF indicator of the
tuner does not light are usable.
•
If there is a TV broadcasting station near by, do not use
the station's channel.
•
The unit may not operate correctly if it is turned on again
immediately after turning off the power while in setting
mode. Pause for a few seconds or more before turning on
the power again.
•
When operating two or more UHF wireless microphone
systems using channels in different groups, ensure that the
systems are at least 100m (330 feet) apart from each other.
(The same applies also when using channels in a group if
the different UHF wireless microphone systems are
installed where they are within sight of each other.)
14

Resetting the Accumulated Time Indication

The time indication accumulates time in hours and minutes
when the WRR-805A is on.
Reset the indication to "00:00" whenever you replace the
batteries so that it can display the running time of the
batteries.
1
Press the MODE button until the accumulated time
appears on the display.
2
Press the SET button.
Accumulated time indication
3
Press the – button.
The time indication resets to "00:00."
While you see "00:00" is flashing, you can go back to
previous value by pressing the + button.
4
Press the SET button.