Operating Components With Remote Control; Remote Control Operation Range; Loading Batteries - Sherwood RD-8601 Operating Instructions Manual

OPERATING COMPONENTS WITH REMOTE CONTROL

Enter the setup code for each component
1
other than this receiver you wish to
control. For details, refer to "Entering a
setup code" on page 16.
Turn on the component you want to
2
operate.
Press the DEVICE button on the remote
3
control corresponding to the component
you wish to operate.
Aim the remote control at the REMOTE
4
SENSOR of the component you wish to
control and press the button corresponding
to the operation you want.
• When operating a Sherwood CD player or tape deck
using digi link system remote control, aim the remote
control at the REMOTE SENSOR of this receiver.
However, to operate a Sherwood DVD player, aim at
the REMOTE SENSOR of the corresponding
component.

LOADING BATTERIES

• When the remote control does not operate, the old batteries should be replaced. In this case, load new batteries within several
minutes after removing old batteries.
• If the batteries are removed or have been exhausted for a longer period of time, memorized contents will be cleared. Should
this happen, you should memorize them again.
Remove the cover.
1

REMOTE CONTROL OPERATION RANGE

• Use the remote control unit within a range of
about 7 meters (23 feet) and angles of up to 30
degrees aiming at the remote sensor.
AUDIO/VIDEO RECEIVER RD-8601
POWER
REMOTE
SENSOR
ON/ OFF
INPUT SELECTOR
STANDBY
AUDIO VIDEO
ON/STANDBY
PHONES
CHANNEL
SPEAKER SELECTOR ADJUST
ON/OFF
7m
POWER ON POWER ON STANDBY ST ANDBY
AUD CD AUX TV
VCR VCR DVD SAT CBL
DEVICE SELECT
CH.SEL CH.SEL
T/V T/V
CH/LEVEL CH/LEVEL MUTE MUTE VOLUME
T.TONE .TONE OSD OSD
MENU MENU SETUP SETUP
ENTER ENTER
SLEEP SLEEP DIMMER DIMMER
DISPLA DISPLAY RETURN
TUNE TUNE TUNE TUNE
PRESET PRESET P .SCAN .SCAN PRESET PRESET
AUTO AUTO DSP DSP STEREO STEREO
ADJUST ADJUST
SPK SET SPK SET PARAMA ARAMATER
TUNER CD AUX TAPE
1 2 3 4
VIDEO 1 VIDEO 2 VIDEO 3
5 6 7 8
EXT. IN
9 0 +10 +10
MACRO MACRO
M1 M2 M3
REMOTE CONTROL RNC-50A REMOTE CONTROL RNC 50A
Load two batteries("AAA" size) matching
2
the polarity.
• Remove the batteries when they are not used for a
long time.
• Do not use the rechargeable batteries(Ni-Cd type).
• Be sure to use alkaline batteries.
15
MASTER VOLUME
SURROUND MODE
DIGITAL
EXTERNAL IN AUTO DSP MODE STEREO
PARAMETER INPUTS
VIDEO 3
SPEAKER DYNAMIC
TONE MODE SETUP RANGE CINEMA EQ MEMO/ENTER TUNING/PRESET T/P MODE FM MODE BAND
VIDEO L - AUDIO - R