Sherwood RX-773 Operating Instructions Manual page 18

Adjusting the tone (bass and treble)
8.
Adjust the tone as desired.
■When adjusting the bass
or
■When adjusting the treble
or
• Each time the buttons are pressed, the tone (BASS and
TRBL) can be adjusted within the range of -10~+10 dB.
■Notes :
• When the tone direct function is activated, the tone mode
cannot be entered and "TON DIR" flickers for 3 seconds.
• Extreme settings at high volume may damage your
speakers.
• In general, the bass and treble levels are adjusted to 0.
Adjusting the sound volume balance
10.
Adjust the sound volume balance between the left and right speakers.
or
9.
To listen to a program source without the tone effect.
or
• "TON DIR" is displayed, "DIRECT" lights up and the sound
that bypasses the tone circuitry will be heard.
• To cancel the tone direct function, press this button again
to display "TON CTRL", and then "DIRECT" goes off.
• Each time the buttons are pressed, the balance level can
be adjusted within the range of L 10~R 10.
■Note : In general, the balance level is adjusted to 0.
18