Your Thread Stand - Quilter's Pro Deluxe User Manual

Your Thread Stand

Your Quilter's Pro Deluxe comes with a four spool thread stand. This thread stand is connected to
the side of your machine and can hold bobbin thread you are using to wind onto your bobbins and the
top thread you are using to quilt. You can also have a second spool of thread on the stand if you are
using two di erent threads on your quilt. This 4 spool thread stand has a telescoping thread holder
which needs to be all the way up when you are quilting to help the thread come off the spool evenly
and smoothly.
Step 1: If the telescoping thread tree is not on the thread
stand then you will need to attach it.
Step 2: Slide the telescoping thread tree into the hole
provided between the tread holders.
Step 3: Using the supplied screw with washer insert from
the bottom side to secure the telescoping thread tree in
place.
Step 4: On the left side of your machine ( the left side of
the machine is the side with the motor) you will see two
screws not holding anything on yet.
See figure 15
Step 5: Loosen these two screws. You don't need to take
them out but they do need to be loose so that you can
slide the thread stand over them.
Step 6: On the thread stand you will see two holes on the
underside which can be placed over the two screws and
then drop into place.
See figure 16
Step 7: Once you have the thread stand in place over the
two screws tighten the screws to hold the thread stand in
place.
See figure 17
Remember to pull the telescoping thread tree to the full up
position to use. See figure 18
Figure 15
Figure 16
Figure 17
Figure 18
9
User Guide |