Adjusting Bobbin Winder For Contact With The Upper Shaft - Quilter's Pro Deluxe User Manual

Adjusting Bobbin Winder and Contact with the Shaft
Step 1: Loosen the three (3) screws (A) holding the bobbin winder in place but do not remove them.
See figure 101
Step 2: Twist the bobbin winder (B) to the right for more contact with the inner shaft or move left for
less contact.
Note: When twisting the bobbin winder (B) you need to stand on the side of the machine with the
access panel.
Step 3: The bobbin winder disk with the friction ring needs to contact the disk on the upper shaft
when engaged. See figure 102
Step 4: Once done moving the bobbin winder retighten the screws to hold the bobbin winder in
place.
Turning the bobbin winder to the right
will move the friction wheel closer.
Turning the bobbin winder to the left
will move the friction wheel away.
Figure 101
Friction Ring
Figure 102
User Guide |
31