Advertisement
3
Connect your wired (Ethernet) devices to the MediaAccess Gateway
If you want to connect a device using a wired (Ethernet) connection:
1 Take the Ethernet cable with the yellow connectors.
2 Connect one end of the Ethernet cable to one of the yellow Ethernet ports on your
MediaAccess Gateway.
3 Connect the other end of the Ethernet cable to your device.
4
Connect your telephones to the MediaAccess Gateway
Connect your corded phone, DECT base station or fax to one of the green ports (
4. Connect your wireless devices to the MediaAccess Gateway
The MediaAccess Gateway has two wireless access points:
The 5 GHz access point offers superior transfer rates, is less sensitive to interference and allows
you to connect IEEE802.11a/n/ac wireless clients.
The 2.4 GHz access point allows you to connect IEEE802.11b/g/n wireless clients. Use this access
point for wireless clients that don't support 5 GHz.
You can connect to an access point:
Automatically using WPS:
a Start WPS Push Button Configuration (PBC) on your
wireless device.
b If your wireless device prompts you to select your
access point from a list, select the item that uses the
Network Name printed on the back label of your
MediaAccess Gateway.
c Shortly press the WPS
MediaAccess Gateway.
d The WPS
e After maximum two minutes, the WPS
Solid green: the registration was successful.
Blinking red: the MediaAccess Gateway could not find your wireless device. Try again or
connect your wireless devices manually.
Manually:
Configure your wireless device with the Network Name and Wireless Key printed on the back
label of your MediaAccess Gateway.
button on the back panel of the
LED on the front panel starts blinking orange.
LED will be in either of the following states:
Wireless key: **************
Network Name: **************
WPS
Network Name
).
Advertisement
