Water Inlet Connection; Drain Hose - Beko WMA 510 S Installation & Operating Instructions Manual

Feet adjustment
To ensure quiet and stable operation, the
machine should be positioned correctly and
leveled. If the machine is unstable, adjust feet
by loosening the plastic lock nut and screwing
or unscrewing the feet until the machine is
level. After positioning, tighten the lock nut.
5

Water inlet connection

Your machine comes with cold water
connection only.
Connect the cold water using the hose with
blue printing or colour.
Cold water supply
For proper operation, the pressure of cold
water should be between 1 and 10 bars. (1
bar corresponds to more
than 8 litres per minute
flow rate with a fully open
tap.)
To prevent water leaks,
sealing washers are
supplied with the water inlet hose inside the
machine. Place these on the hose end and
tighten both ends fully.
In order to prevent any water leakage and
damage, turn off the water tap when not in
use. Connect the right angled end of the hose
to the machine water inlet.
The washing machine must only be
connected with the new hose provided and
old hoses must not be reused.
60° 90°
60° Start / P ause
40° Cot t on s Cancel Prewash
Sy nt h et i cs 40°
30° Col d
Col d
A Clas s 40°
Delicates 30° Mini 30 '
Col d Hand Wash
Woo l l ens Ready Wash Sp i n /En d
Rinse
40° Sp i n + Dr ain

Drain hose

The drain hose should be placed and secured
either at the side of the sink A, directly to the
drain B or directly to the waste water
inlet C.
• The hose should not be bent.
• Using method A, the drain hose should be
secured with the elbow so that it can not
be dislodged.
• The waste pipe must only be connected
into the foul drains and not surface water
drainage system.
• The hose should be placed between 20 and
80cm from the floor level and must not be
extended otherwise the machine may not
empty the waste water.
• The minimum diameter of any external pipe
must be 32 mm.
6
Hol d Rinse Rinse Ex t r a
On/Off