Cleaning The Pump Filter - Beko WMA 510 S Installation & Operating Instructions Manual

Pump filter warning
When the appliance is in use and depending
on the programme selected there can be hot
water in the filter. Never remove the filter
during a wash cycle, always wait until the
appliance has finished the cycle, and is empty.
When replacing the filter, ensure it is securely
retightened so as to stop leaks and young
children being able to remove it.
Hoses
To prevent any leakage, check the hoses
every two years. If the machine is placed in
cold ambient temperatures, the water
remaining inside the pump and hoses should
be drained to prevent freezing, empty the
water intake hoses by disconnecting from taps.
Drum
Do not leave any metal objects (pins, needles,
etc.) inside the drum. These objects may cause
rust on the drum surface and stain clothing.
Do not clean the drum with abrasive materials.

Cleaning the pump filter

Warning
Hot water danger! Always ensure that the
drum is completely empty. Be careful while
taking out the filter!
Switch off the appliance. Open the filter
cover by pulling at the holder as shown.
Open the filter as shown turning the cap
anti-clockwise, drain the water. If there are any
foreign parts inside the filter, take them out
and clean the filter before replacing it. Then,
place the filter while turning it clockwise. When
securely tightened, close the filter cover.
15