Using The Console Port - 3Com Hub 1000 SX User Manual

A
U
SING THE
The Hub 1000 SX is ready to use and requires no configuration. However,
on rare occasions you may need to confirm a POST failure, change a
port's configuration, or update the firmware image to install a bug fix or a
standards update. The console port provides access to a simple scrolling
command line interface (CLI). By connecting the console port to a PC, you
can perform these tasks:
Configure port settings
Display hub status
Update the firmware image
The console port (a DB-9 standard male connector) is located on the
Hub 1000 SX rear panel. See Figure A-1.
AC REFER TO
INSTRUCTION MANUAL
!
FOR CORRECT
IN ®
SELECTION OF
POWER CORD
CAUTION: For continued protection
against risk of fire use only with same
type and rating of of anti-surge fuse.
INPUT
SUPPLY DATA
V 5
FUSE V~ H z A
2.0 A 100-240 50/60 1.0 A max 8.5
Figure A-1 Console Port
The console port default settings are:
9600 baud
8 data bits
1 stop bit
No parity
Auto-baud and modem connections are not supported.
C
ONSOLE
3Com Corporation
Santa Clara, CA
Made in USA
DC POWER CONSOLE
+12 -12
2.5 1.0
P
ORT
RESET
Console
GBIC