Sharp MD-E9000H Operation Manual page 43

Timer and Sleep Operation (continued)
5
Press the MEMORY/ENTER button to set the sleep time.
6
The unit will enter the stand-by mode automatically after the pre-
set sleep time has elapsed.
To cancel the sleep operation:
Setting the unit to the power stand-by mode cancels the sleep operation.
You can also cancel the sleep operation by the following steps without setting the unit
to the power stand-by mode.
1. Whilst in the sleep operation, press the SLEEP button.
2. Within 10 seconds, press the MEMORY/ENTER button. "SLEEP" indicator will go
out.
To confirm the remaining sleep time:
1. Whilst in the sleep operation, press the SLEEP button.
2. Within 10 seconds, press the 5/3 or 2/4 button to select "SLEEP". The
remaining sleep time will be displayed.
After 10 seconds, the display will return to normal.
If you press the MEMORY/ENTER button whilst the remaining sleep time is dis-
played, you can change the sleep time. (Perform steps 4 and 5 above.)
Notes:
Once the sleep time is set, it will remain unchanged until a new time is entered.
The sleep functions cannot be used to control the device connected to this unit.
You must use its sleep functions, if it has them.
*MD9000H-E41-44 43
Simultaneous sleep and timer operation
1
Perform steps 1 - 3 on pages 42 - 43, "Sleep operation".
2
Perform steps 1 - 11 on page 41, "Timer playback/Timer record-
ing".
1 Sleep timer setting
2 Timer playback
Timer playback
(record) setting
(record) start time
1 minute - 2 hours
Sleep operation will
automatically stop.
Web-site: www.sharp.co.uk/support Help Line: 08705 274277 (office hours)
2001.4.20, 2:15 AM
MD-E9000H
Desired time
End time
43
1
2
3
4
5
6
7
8
9
10
11
12